Automotive Ecu Repair

Automotive Ecu Repair

High automatic BGA rework machine with visual rework procedures, easy to replace your renewed(reballed) chip at its right position on the chip;Even automatically remove, pick up, replace and solder etc.; Used temperatures profiles can be saved and convenient to be applied again.

Description

                                High automatic rework machine for Automotive ecu repair

 

 

Automotive Ecu Repair Much time and expertise you have to spend or master are often used during reworking, because you don't have an automatic BGA rework machine with intelligent operation for heating up, desoldering, mounting and soldering, even temperatures recorrected.

mercedes benz ecu repair

Basic information

Model DH-A2E
Power supply 110~220V +/- 10% 50/60Hz
Rated power 5000W
Upper heating Hot-air which can be adjsuted
Bottome heating Hybrid heating for PCBa and chip-level
Mounting Optical alignment, visible procedures, accuracy 0.01mm
PCB size 10*10~450*500mm
Chips 1*1~80*80(more than 80*80mm, optional)
Automation level High-automatic
After-sales Online guide and traning (video-calling if need)
Soldering ball Lead or lead free and solder paste( user providing)
Power plug As customer's requirement
Frequency 3 hours working, 10 minutes rest
Chip-feeder Automatically carry a chip to solder or receive and go back
Optical CCD Automatic
Side camera Observe status of solder ball melting(optional)
Dimension 600*700*850mm
Weight 70kg

 

Rework procedures:

1.Desoldering and heating

car ecm repair cost

 

Hybrid heating with infrared and hot-air ways:

Infrared heating for PCBa, especially those PCBa which were idle for a long time, to be preheated.

Hot-air heating for chips(components) to be heated for desoldering, whose function is same as 

upper hot-air, generally, upper hot-air and lower hot-air need to be working at the same time. 

2. Reballing or printing solder paste

reablling jit

To reball or print solder paste after cleaning motherbooard and chip's pads, then make them concreted 

on chip or motherboard, waiting for soldering. 

3. Optical CCD and chip feeder

chip picked up

The optical CCD and chip-feeder work together, which automaticall pass out a chip

for picking up or receiving a chip and carry it back.

4. Mounting for renewed chip or components

Mounting for chip

Visible aligning procedures which can make you rest assured to mount, even smaller chip and spacing. you just need to click "alignment OK" after micrometers adjusted, then automatically solder back. 

5. Soldering 

 soldering chip

Automatically put it back in its right position on the motherboard, accuracy 0.01mm which meets various chips mounting and different 

motherboards etc. 

6. Monitoring(Optional function)

Monitoring and sodlering

During the soldering

the status of melting can be observed through side-camera. Sure, desoldering status can be seen using the same way. 

the video will be shown on monitor which is be used for optical CCD imaging on.

More details about soldering for automotive ecu repair, here is a video for your reference:

 

(0/10)

clearall